Installation methods for SOFT SOUND™ Anechoic, Pyramid & Bass Wedge studio foams

adhesive mounting
Adhesive mounting is ideally suited for permanent installations requiring speed and ease of application. This installation method requires little to no layout time, depending on various field conditions. Adhesive mounting forms a strong bond between the panel and wall. These instructions were created for 24 x 48 inch foam panels and intended to serve as a guide. Install foam panels with 12 x 12, 24 x 24 and 48 x 48 inch dimensions in a similar manner. These instructions also apply to our Class A studio foams. The responsibility for recognizing and compensating for field conditions lies with the installer.

adhesive mounting

Adhesive mounting is ideally suited for permanent installations requiring speed and ease of application.
This installation method requires little to no layout time, depending on various field conditions.
Adhesive mounting forms a strong bond between the panel and wall.

These instructions were created for 24 x 48 inch foam panels and intended to serve as a guide. Install foam panels with 12 x 12, 24 x 24 and 48 x 48 inch dimensions in a similar manner. These instructions also apply to our Class A studio foams. The responsibility for recognizing and compensating for field conditions lies with the installer.

tools & materials
tools: screw gun, level, tape measure and pencil

installation steps
1) Wall surface should be clean and free of any surface obstructions. 2) Using a level, lay out where the panels will be installed across the entire wall surface. Lightly draw reference lines with a pencil as needed (figure A). 3) Confirm measurements before installing. If necessary, make all field cuts before installing. See our field cutting instructions. 4) Lay the foam panel, textured side down, on a clean, smooth surface. Apply a 3/8 inch line of adhesive around the perimeter of the panel and from corner to corner. Apply a few dots of adhesive where necessary. (figure B) 5) Using the reference lines as a guide, gently press the panel against the wall. Hold the panel in position for a few moments while the adhesive sets. (figure C)

installation steps

1) Wall surface should be clean and free of any surface obstructions.

2) Using a level, lay out where the panels will be installed across the entire wall surface. Lightly draw reference lines with a pencil as needed (figure A).

3) Confirm measurements before installing. If necessary, make all field cuts before installing. See our field cutting instructions.

4) Lay the foam panel, textured side down, on a clean, smooth surface. Apply a 3/8 inch line of adhesive around the perimeter of the panel and from corner to corner. Apply a few dots of adhesive where necessary. (figure B)

5) Using the reference lines as a guide, gently press the panel against the wall. Hold the panel in position for a few moments while the adhesive sets. (figure C)

other helpful information